| 极地冰层回转钻进切削热量测试装置的研制 |
| 投稿时间：2013-10-01 修订日期：2013-10-01 点此下载全文 |
| 引用本文：刘春朋,曹品鲁,白杨,等.极地冰层回转钻进切削热量测试装置的研制[J].钻探工程,2013,40(12):13-17.LIU Chun-peng,CAO Pin-lu,BAI Yang,et al. Development of Test Stand for Measuring Cutting Heat Generated in Polar Ice Drilling[J]. Drilling Engineering, 2013,40(12):13-17. |
| 摘要点击次数: 952 |
| 全文下载次数: 593 |
|
| 基金项目:国家自然科学基金青年科学基金（41006158）、教育部博士点基金（2011006112007） |
|
| 中文摘要:极地冰盖深部“暖冰”层钻进时，由于冰层的温度较高，接近甚至达到冰的压力熔点，回转钻进时产生的切削热量极易使冰屑融化，导致机械钻速慢、取心率低、卡钻事故频发。钻压、转速、切削具结构等参数均对切削热量有一定的影响，有必要设计一套实验装置对切削热量进行测试，从而为设计切削具结构、优化钻进参数组合提供理论依据。以XY-1型岩心钻机钻进系统为平台，利用无线信号传输原理设计了冰层回转钻进切削热量测试实验台。初步测试结果表明，该实验装置能够准确测量钻压、扭矩、切削温度等参数，可用来进行相关的实验研究。 |
| 中文关键词:极地钻探 深部冰层钻探 冰心 “暖冰” 切削热 切削温度 测试装置 |
| |
| Development of Test Stand for Measuring Cutting Heat Generated in Polar Ice Drilling |
|
|
| Abstract:Cutting heat generated during rotary drilling is extremely easy to melt ice located in warm ice layer of deep ice cap because the high temperature is almost close to or even reach ice pressure melting point, which results in low penetration rate, poor core recovery and frequent sticking accidents. So it is necessary to design a device to test the cutting heat which is influenced by WOB, rotation speed and the structure of cutting tool; the test results would provide the theoretical basis for the design of cutting tool structure and optimization of drilling parameters. With the XY-1 core drilling system as the platform, using the wireless signal transmission principle, the test stand for testing cutting heat generated during rotational drilling in ice layer is designed. Preliminary test results show that by this experimental device, the parameters of WOB, torque and cutting temperature can be accurately measured, which can also be used for the related experimental study. |
| keywords:polar drilling deep ice drilling ice core “warm ice” cutting heat cutting temperature test stand |
| 查看全文 查看/发表评论 下载PDF阅读器 |
