海上窄压力窗口控压固井浆柱结构设计方法 |
投稿时间:2023-05-04 修订日期:2023-10-08 点此下载全文 |
引用本文: |
摘要点击次数: 90 |
全文下载次数: 0 |
|
|
中文摘要:针对海上窄压力窗口固井顶替效率低下的技术难题,通过轻钻井液的施加以优化浆柱结构以及施加环空回压的方法实现安全高效固井的目标。考虑停泵压胶塞环空回压值不超过 5MPa、前置液环空紊流接触时间大于10分钟以及注替结束井筒自压稳三个关键技术要求,合理优化固井浆柱结构,计算控压固井全过程井筒ECD,使井筒ECD在安全密度窗口内,形成了海上窄压力窗口控压固井浆柱结构设计方法。以乐东10-1气田某高温高压井为例,优化设计了该井的浆柱结构,并模拟计算了控压固井全过程井筒ECD及紊流接触时间。结果表明:轻钻井液用量为14 m3~50m3且密度在1.822 g/cm3~2.142g/cm3之间、前置液用量大于13m3且密度在2.36 g/cm3~2.45 g/cm3之间、水泥浆密度在2.4 g/cm3~2.51 g/cm3之间,可实现冲洗液紊流接触时间大于10min且满足压稳不漏的固井要求。结论认为,该设计方法可实现海上窄压力窗口井提高固井顶替效率和安全施工的要求。 |
中文关键词:海上 窄压力窗口 控压固井 浆柱结构 回压补偿 紊流接触时间 |
|
Design method of slurry column structure of managed pressure cementing at offshore gas wells with narrow pressure window |
|
|
Abstract:Aiming at the technical problem of poor cementing quality at offshore gas wells with narrow pressure window, the goal of safe and efficient cementing is achieved through the application of light drilling fluid to optimize the slurry column structure and the application of annular backpressure. Three key technical requirements are considered in this paper: the annular backpressure value during the pump stopping process should not exceed 5MPa, the turbulent contact time of the lead fluid should be greater than 10 minutes, and the wellbore should be self-stabilizing after cementing ending. Then the optimized slurry column structure and the calculated wellbore equivalent cycle density (ECD) with managed pressure cementing (MPC) technology were conducted which formed a design method of cementing slurry column structure of MPC for offshore gas wells with narrow pressure window. Taking a high-temperature and high-pressure well in Ledong 10-1 gas field as an example, the cementing slurry column structure was optimized, and the wellbore ECD and turbulent contact time was simulated during entire MPC process. The results indicate that: light mud with the volume of 14 m3~50m3 and the density of 1.822 g/cm3~2.142g/cm3, pad fluid with the volume greater than 13m3 and the density of 2.36 g/cm3~2.45g/cm3 and cement slurry with the density of 2.4g/cm3~2.51g/cm3, which can achieve the requirements of turbulent contact time greater than 10 minutes and leakproof pressure stability. The conclusion is that, the goal of improving the efficiency of cementing displacement and safety construction is feasible with this method. |
keywords:Offshore Narrow pressure window MPC Slurry column structure Back pressure compensation Turbulent contacting time |
查看/发表评论 下载PDF阅读器 |
|
|
|