句容赤山湖地热井成井工艺方法
投稿时间：2013-03-04  修订日期：2013-03-04  点此下载全文
引用本文：陈进宝,苏金宝,陈娟,等.句容赤山湖地热井成井工艺方法[J].钻探工程,2013,40(8):35-38.
CHEN Jin-bao,SU Jin-bao,CHEN Juan,et al. Drilling Technology of Chishanhu Geothermal Well in Jurong[J]. Drilling Engineering, 2013,40(8):35-38.
摘要点击次数: 1126
全文下载次数: 735
作者单位E-mail
陈进宝 江苏省地质勘查技术院 jin.su@163.com 
苏金宝* 河海大学地球科学与工程学院 jin.su@163.com 
陈娟 江苏省地质勘查技术院  
杨春光 句容市赤山湖管理委员会  
曹勇 句容市赤山湖管理委员会  
基金项目:国家自然科学基金项目(41202154)资助
中文摘要:江苏句容出露发育广泛白垩系红色细砂岩、泥质砂岩，浅埋于松散层之下，水文地质条件极差，地下水贫乏，钻井多数为干孔。通过钻探施工，句容赤山湖地热井先期排水量在2～3 m3/h，通过对其地质含水条件的分析，提出了应用深水泵与“脉动排砂法”，分选抽水层位等新的施工、洗井、抽水工艺理论，最终使该井日产高达500余m3。该井的成功对贫水地层找水以及碎屑岩区洗井排水具有巨大的借鉴意义与实用价值。
中文关键词:地热井  贫水地层  施工方法
 
Drilling Technology of Chishanhu Geothermal Well in Jurong
Abstract:Widely developed Cretaceous red sandstone and argillaceous sandstone outcropped in Jurong of Jiangsu, which were shallowly buried in unconsolidated layers under very poor geological conditions. Because of the shortage of groundwater, most drilling encountered dry holes. Only by simple drilling, the initial output of the geothermal well in Jurong was about 2～3m3/h. After the analysis on geological conditions of water-bearing, some new process theories of construction, well washing and pumping were put into application: deep water pump and “sand discharge by pulsation”, and sorting pumping horizon; water output was up to more than 500m3/day. The success in this well has practice value with reference significance to the water research in water-lacking layer and well-flushing in clastic rocks.
keywords:geothermal well  water-lacking area  construction method
查看全文  查看/发表评论  下载PDF阅读器