| 热压烧结金刚石钻头工程勘探钻进时效的试验研究 |
| 投稿时间：2013-10-23 修订日期：2013-10-23 点此下载全文 |
| 引用本文：刘全心,方小红,刘青.热压烧结金刚石钻头工程勘探钻进时效的试验研究[J].钻探工程,2013,40(12):54-57.LIU Quan-xin,FANG Xiao-hong,LIU Qing. Experimental Research on the Drilling Efficiency of Hot Pressing Sintering Diamond Drill Bits in Engineering Exploration[J]. Drilling Engineering, 2013,40(12):54-57. |
| 摘要点击次数: 1068 |
| 全文下载次数: 640 |
|
|
| 中文摘要:采用热压烧结方法制备5种不同胎体硬度和唇面形状的金刚石钻头，试验于工程勘探中，与常用的电镀金刚石钻头比较，分析其钻进时效情况。结果表明：通过优化设计，热压烧结钻头同样适用于工程勘探领域，其钻进时效与现行电镀钻头的钻进时效相当，甚至更高；对于微风化灰岩地层，热压烧结钻头的胎体硬度越低，其钻进时效越高，胎体硬度越高，其钻进时效越低；异形齿设计比平齿设计的热压烧结钻头的唇面更易出刃，其钻进时效较高。 |
| 中文关键词:热压烧结 金刚石钻头 工程勘探 钻进时效 |
| |
| Experimental Research on the Drilling Efficiency of Hot Pressing Sintering Diamond Drill Bits in Engineering Exploration |
|
|
| Abstract:5 kinds of diamond drilling bits were prepared with different matrix hardness and profiles by hot pressing sintering method, which were tested in engineering exploration and compared with the common electroplated diamond drilling bits to analyze the drilling efficiency. The result shows that by optimized design, the hot pressing sintering diamond bits are suitable for engineering exploration equally, their drilling efficiency are almost equal to or even higher than that of the electroplated diamond drilling bits. In weathered limestone formation drilling, the lower the matrix hardness of hot pressing sintering bit, the higher the drilling efficiency, and vice versa. The profile of bit by special teeth design is faster exposed than that by plain teeth design with higher drilling efficiency. |
| keywords:hot pressing sintering diamond drill bit engineering exploration drilling efficiency |
| 查看全文 查看/发表评论 下载PDF阅读器 |
