Research on the Pick Arrangement Pattern of Rotary Drilling Buckets Based on Pick Cutting Test
DOI:
Author:
Affiliation:

1.Institute of Beijing Sany Intelligent Technology Co., Ltd;2.InsKunshan Changying hard material Technology Co., LTD;3.Kunshan Changying hard material Technology Co., LTD

Clc Number:

Fund Project:

  • Article
  • |
  • Figures
  • |
  • Metrics
  • |
  • Reference
  • |
  • Related
  • |
  • Cited by
  • |
  • Materials
  • |
  • Comments
    Abstract:

    During the construction of rotary drilling rig, the efficiency of rock drilling is closely related to the pick arrangement of core barrel. The key pick arrangement parameters of core barrels are studied by using pick cutting test system. Three-dimensional load, crushing volume, deformation displacement, broken morphology and other data were collected during the test process. From multiple dimensions such as crushing specific power, cutting resistance, load fluctuation, and pick spin, the controlled variable method is applied to conduct pick cutting experiments, quantitatively evaluating the effects of cutting angle, tooth deviation angle, cutting sequence, tooth tip height difference, and tooth tip trajectory spacing on rock cutting. Research has shown that there is an optimal combination of tooth arrangement parameters that match the geological properties. Taking drilling into granite formations as an example, the optimal range of tooth arrangement parameters was determined, which are: cutting angle 68-72 °, tooth deviation angle 5-15 °, skip cutting, tooth tip height difference of about 3 mm, and tooth tip trajectory spacing of about 30 mm. According to the test results, the drilling efficiency is increased by 13.64% and the cost of unit footage is reduced by 39.13%. The research results are of great significance for guiding the arrangement of the core barrels, reducing the gear loss and improving the drilling efficiency.

    Reference
    Related
    Cited by
Get Citation
Share
Article Metrics
  • Abstract:
  • PDF:
  • HTML:
  • Cited by:
History
  • Received:March 21,2024
  • Revised:August 07,2024
  • Adopted:September 06,2024
  • Online:
  • Published: